Material requirements - Stamped parts
Stamped parts for window regulators, seat adjusters and latch systems
stamped parts (weight: 50 grams up to 1,500 grams) made of blank, hot dipped galvanized or aluminium steel coils. Material thickness 1.0mm up to 5.0 mm
pre-finished, partly with thread, press bolt or press nut
partly improved by painting, powder coatin or galvanizing
required stamping pressure from 250 to up to 800 to
Fine blank parts for window regulators and seat adjusters
fine blank parts (weight: 200 grams up to 500 grams) made of stripped steel coil, material thickness 2.0 mm up to 6.0 mm
pre-finished, partly hardened and tempered or annealed
required stamping pressure: 250 to up to 800 to
pre-finished, partly hardened and tempered or annealed
required stamping pressure: 250 to up to 800 to
